Can anyone help me find an article about using plywood as edgebanding to get a perfect match? I'm trying to design a vanity using 1-1/2" thick case parts and inset drawerfronts. I will probably end up using some hardwood as the 1-1/2" edgebanding, but so far, I am having a hard time getting the Walnut hardwood and plywood to match.
I was also considering making this thing out of a new Bamboo plywood that a friend showed me. The plywood was really interesting, but I would have to use the plywood for edgebanding.
I'm sure that I could figure something out, but sometimes it's better to find a technique that is already in play. I won't need to re-invent the wheel.
Thanks,
RC