Folks....I'm at a point where I need to make a major decision about my new shop. My new shop is 30x24....I had a desire of putting a small finishing room in one corner of it. The finishing room would be 8x8 or 8x10 with a finished ceiling height of 9'7". I will probably never spray finishes just brush or wipe-on. I'm at the point where I need to either frame it in or give up on the idea altogether. The big sticking point is heating and ventilating it. I live in a cold climate and will be heating the shop by a NG outside vented (exhaust and fresh air) gas heater. What do you folks do for finishing......what's your opinion on a small finishing room in a 720 sq.ft. shop. If you recommend a finishing room what would you do for heat and ventilation? If you recommend No finishing room, how would you handle finishing?