I have a small room off my shop that has been designated a finish/clean room.
I have in-floor heat with concrete floors. That particular room is on a different heat zone than the shop so it gets/stays pretty warm like 78-80 degrees where the shop is 60-62 degrees.
I take my projects in the finish room to apply oil and varnish type finishes.

Question: should I be concerned with the heat of the room "cooking" the finish to fast?? I use Wipe on poly most of the time over BLO. The heat is dry but like I said it is pretty warm. Are there any other issues with finishing in this room that I need to watch out for??
Thanks in advance for the input!!