I'm looking for a vert. 2 1/4" crown molding cutter for my 1 1/4" bore shaper. Any ideas??
I'm looking for a vert. 2 1/4" crown molding cutter for my 1 1/4" bore shaper. Any ideas??
Perhaps an insert tool head such as this one from FS Tools?
Regards, Rod.
http://www.fstoolcorp.com/Templates/...28/C10_C11.pdf
Hey Mark,
I have a corragated head from CG Schimdt, with plenty of knives.... IF it is a simple one off quick job you might what to consider Grizzly
Paul
I have the Grizzly cutter. I just never found a consistant way to run it. I set up my power feed which helped a bit. I ended up just buying a W&H moulder which does a great job.
Quinn
In my experience, running crown on a shaper is a PITA. It can be done but if you are going to be running a lot of crown on a fairly regular basis, you might want to consider investing in a small moulder like the W&H so you can run the crown flat.
David DeCristoforo