Hey all,

I'm in the process of building a workshop in my basement.

Currently I have a 1950's Delta Homecraft table saw that was my grandpa's. At some point in the near future I would like to upgrade my table saw to a cabinet style saw. To be prepared for the switch, I want to put in a 230V receptacle now while the walls are still accessible.

The receptacle will be about 35ft from the disconnect I am going to use. What size wire do I need?

Since I don't have a saw yet, anything else I can do now in preparation for the future?

One more thing, my PSI dust collector is currently 115V. It's a 2hp motor that draws 18 amps. I was planning on putting this on it's own 20a/115v circuit but should I switch it over to 230v as well?

Thanks!
Doug