Hi Fellow creekers,
I have a border made up of three squares. I'd like to colour code all 4 sides to colour map to decrease Laser time...how can I change the colour of each side ( as the square is continuous) if I select blue all 4 sides go blue. I need each side a different colour.....if I can achieve this do you think it will save much time??? It takes an hour to do a timber plaque slightly larger than A4. I have a 35 watt Epilog!!!
Your help appreciated.
Regards,
Ian Wilson
PS Sorry to read the posts of those in the States doing it real tough..I sincerely hope it gets better real soon. Australia says its out of the woods but our new Govt has spent all our savings and put us in debt...we may not have seen the worst of it yet.