Hello there again, hopefully someone can help me with this. I was browsing through our stock and noticed some AlumaMark in the back. I asked the owner about it and he mentioned it didn't turn out to well, the manufacture told him our lasers were too powerful. But of course this got my attention and I did some research. I've searched the net and searched here but I haven't found model specific power/speed/resolution settings. I tried it out (gold mat finish) in our Epilog 32 and found that 70s 20p turns out "ok" but I've seen MUCH better results on internet samples. If anyone could point me in the right direction on how to engrave this material that would be GREAT. I've seen good directions but not with any of the machines that we have, and this material seems to be very sensitive -
The machines we have are -
Epilog 24EX - 75 watt
Epilog 32 - 75 watt
Epilog Radius - 100 watt
I am familiar with ceramark tape and sublimation but if I could get this to work it "could" save some money on material/production time.
Thank you so much in advance!
Edward
Primary Engraver
PS - I also have some JDS samples of their same type of material