I'm going to replace the fence faces on my G0691 with a piece of corian and had a couple of questions. One is extreme n00bness on my part and I'm looking for some sound ideas.
1) What is a good way to lay out the drill points so that they match the fence? Measuring is the obvious first conclusion I came to, but was wondering if there other more sure fire ways of doing that. I tried using the existing fence faces but the problem is... they flex and stretch. I used them to layout the current fence (plywood) and a few of the holes were misaligned enough to cause issues bolting it down using all the fasteners.
2) Will this cut ok on my saw or should I replace my WWII blade with something cheaper to prevent it from damaging my blade? If I do that... do I need to worry about chip out or anything like that?
The place I got it from use a delta unisaw with a forrest blade, so I'm guessing it should be ok - but you guys haven't steered me wrong yet, so I thought I'd lean on your experience.
Thanks in advance!