Cutlist Questions

[Bob Elliott]

I drew some lower kitchen cabinets using Stetchup and then tried to run Cutlist. I used mostly 3/4" plywood for the carcasses with 1/4" plywood for the backs. Cutlist didn't show the plywood after I added the 1/4" plywood.

Is there a way to use to different thicknesses of plywood and get a cutting diagram from Cutlist?

[Don Selke]

Are you using Cutlist/plus? If so, you need to add the 3.4" plywood to your raw materials list. Click on raw materials, then sheet goods and see if 3/4" plywood is added. If not, you need to add the product. If you are using the cutlist program for sketchup, you need to make everything a component or a group. Hope this helps.