Well, I have ran into a few snags unfortunately. The first being the two throat inserts provided by Grizzly are warped. One is so bad it is unusable the other one is a lot closer but still almost unusable. The Second thing being my top is also warped around the back of the throat plate area. I don't have a feeler gauge at home so I cant judge how far out is but as you can see in the pictures it seems enough to warrant concern on my part. The Delta Contractor saw that this saw is replacing is basically perfectly flat from one wing end to the other. I guess I am going to get to find out about the Great Grizzly customer service a little sooner then I wanted to. Other then these two issues so far everything else seems to be working fine. I haven't gotten to trying to align everything yet though because I don't want to waste my time if the top really is to far out.