Ok, this one is probably really dumb:
If I have a miter gauge that I know to be true (in my case the Incra V27) at 90 degrees as well as the other stops... And that miter gauge has an extension fence/board affixed to it permanently...
Could I devise a simple sled that would just hook over the edge of my miter gauge fence and thus I'd get a sled, as well as the accuracy of the Incra? (as opposed to affixing runners to the bottom of the sled)
I've only used a sled once, during my woodworking course to trim the table top to final dimensions, so perhaps I'm not thinking through the various applications well enough.
Thanks!!!