I have a ILS12.150 and it is doing something funky.
I will be doing a large engraving, ~20" x 20" and it gets 1/2 - 2/3 through and the laser will jump to the right ~10" and continue the program. This never happens at the same place.
The engraving shows right on the UCP screen and I have tried running the file from different software.
I can pause the engraving and restart the engraving and it homes and starts off from the beginning of the engraving again at the right spot.
Universal says change the belt and the bearings, which I ordered, and if that doesn't fix it, an X drive motor ($800 ouch!).
Has anyone else seen anything like this?
Thanks for your advice and recommendations.