The switch and rpm indicator stays illuminated when the PM 2800 DP is plugged in but not turned on.
Has anyone put a solution into place with a master switch on the so it isnt illuminated until you get ready to use it?
The switch and rpm indicator stays illuminated when the PM 2800 DP is plugged in but not turned on.
Has anyone put a solution into place with a master switch on the so it isnt illuminated until you get ready to use it?
After a little research and taking a chance on the 2800 (with some of the bad reviews here at SMC), I love the 2800, no vibrations, excellent fit/finish, no runout, except for what you are trying to fix. I have just been unplugging it when I'm done for now. I may look into taking off the front switch cover and figure out how to wire the digital lights into the on-off switch. My 2700 shaper is the same way, but that is on a 220 wall switch that is always off anyway as an added safety feature when changing cutters.
I have just been unplugging it. I have considered wiring in a switch, but haven't done it.