[OP]
Member
Here is my latest attempt at turning. Made of cedar. The body is a glue up of 8 pieces cut at 22.5 deg. Turned into a cylinder. The top is made of flat boards glued up and then turned into a cone shape. The bottom is attached with pocket screws so it can be remover for cleaning. Finish is spray exterior poly.
The cylinder is 5 1/2" in diameter and the house stands 10" high.
The shingle effect is done with a wood burner.
Thanks for lookinghttp://www.sawmillcreek.org/attachme...id=14942&stc=1
Those who sense the winds of change should build windmills, not windbreaks.
Dave Wilson
Member
Very nice design there Dave and it looks like a lot of work went into it.
Nice job.
Dick
No Pain-No Gain- Not!
No Pain-Good
Contributor
David -
Nice job! Very unique design. I really like the shingle effect.
What is the hole diameter? Put out a For Rent sign, it should have some occupants come spring.
Ted
[OP]
Member
The hole is 1 1/8" diameterOriginally Posted by Ted Shrader
Those who sense the winds of change should build windmills, not windbreaks.
Dave Wilson
Member
Very nice
BTW are you staying warm up there? Sure has been cold here!
Chad
Better to keep silent and be thought a fool, then to open your mouth and remove all doubt.
[OP]
Member
Just checked the temp at 10:00 AM and it is up to 13 below. They are sayiny we could be above zero on tuesday.
Those who sense the winds of change should build windmills, not windbreaks.
Dave Wilson
Posting Permissions
Reply With Quote