Results 1 to 15 of 24

Thread: More problems, Now with the Raised Panels

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 01-16-2005, 7:03 PM #1
    Jack Diemer's Avatar
    Jack Diemer
    Jack Diemer is offline [OP] In Memoriam
    Send a message via AIM to Jack Diemer Send a message via Yahoo to Jack Diemer
    Join Date
    Feb 2003
    Location
    Overland Park, KS
    Posts
    359

    More problems, Now with the Raised Panels

    I glued up a couple pieces of poplar to make raised panels.

    I routed in the raised panels and ended up with these weird voids on the raised panel where the two pieces of poplar were glued up. The voids were on both the top and the bottom of both panels I cut. Two of the voids are in a triangular shape, and the other two look like a dovetail shape.

    I can not for the life of me figure out what causes this.
    Attached Images Attached Images
    If at 1st you don't succeed, go back to the lumberyard and get some more wood.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Raised panels on table saw
    By Jim Dunn in forum General Woodworking and Power Tools
    Replies: 4
    Last Post: 01-03-2005, 10:17 AM
  2. raised panels
    By Aaron Kline in forum Neanderthal Haven
    Replies: 2
    Last Post: 12-19-2004, 2:22 PM
  3. Router for raised panels.
    By James Carmichael in forum General Woodworking and Power Tools
    Replies: 10
    Last Post: 10-05-2004, 12:30 PM
  4. raised panel question
    By Kurt Loup in forum General Woodworking and Power Tools
    Replies: 3
    Last Post: 08-27-2004, 6:03 PM
  5. I have a problem with raised panels....
    By Greg Tatum in forum General Woodworking and Power Tools
    Replies: 10
    Last Post: 05-24-2004, 9:22 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules