I would appreciate anyone's help on this.
I am new to CNC.
I have a torchmate 2x4 router and vcarve pro. I was cutting an intricate design that was running fine. I went to eat dinner and when I returned 45 minutes later the router had gone haywire. It seems that right after I left the z axis dove into the workpiece and through the table. Eventually it came into contact with one of my t tracks where it apparently became lodged. Now I cannot raise or lower the z axis. All the other axises move, except z. The motor makes a humming sound like it wants to move but then starts this bad skipping sound.
What have I done?
Thanks you in advance,
Mitch