[OP]
Member
I would like this, but my shop is on the small side now due to being a pack rat and am satisfied with my General 15". Anyway, some of these auctions do not go too high, some go way higher than they should.
Hopefully a Forum member might find a value here .
http://www.gcsurplus.ca/mn-eng.cfm?s...<nf=1&test=1
They have a nice Drill Press on the Block if you are a QUebec local. I have this model myself and they are nicely built.
http://www.gcsurplus.ca/mn-eng.cfm?s...<nf=1&test=1
Last edited by Bob Slater; 04-14-2011 at 9:25 AM.
Bob S.
http://www.lancasterfm104.com/history.html
[OP]
Member
Bumped in case any Ontario residents need a Big Delta Band Saw/ 16 hours to go.
Bob S.
http://www.lancasterfm104.com/history.html
Contributor
It looks like it has a welder on it, which makes me think it's possibly a metal cutting saw and may turn too slowly for effective wood cutting. That's just an FYI for someone to think about before bidding.
Member
I saw basically the same saw at A&M Hardwood in Ontairo.. It said metal working saw on it.. I figure they changed the pulleys to speed it up a bit ..
Posting Permissions
Reply With Quote