Hey folks...I wanted to share my Joe's build that I have been working on for the past few months. It has been a extremely frustrating but rewarding experience. I went with the Rack and Pinion drive with CNCRouterparts G540 Nema 23 kit. Joe's board has been a big help as I have ran into an enumerable amount of problems but in the end the machine is pretty much working. I still have a lot to do including Limit switches, Edge finder, and Z finder. Not to mention learning CNC'ing in general. I can tell you this much so far I am still amazed every time the thing moves!!
Want to send special thanks to Mike Heidrick who helped me more than any other. Without him I don't think I would have finished.
Quickshot 2011-03-13 at 19.58.39.7010..jpg
Quickshot 2011-03-24 at 20.49.53.7600.jpg
Photo Apr 29, 7 12 21 PM.jpg
Photo Apr 30, 6 12 11 PM.jpg