I am doing a bid for plaques out of corian. They will be 9x11 routed edge and mainly text (17 point AKA Posse). I would appreciate it if any of you cnc gurus could give me an approximate run time for just one and maybe a sheet of them.
I believe I could get about 21 plaques per 96x32 sheet.
Is it faster to do the text on the router or laser? (22 minutes at 30 watts)
I know this takes me about 20 minutes by hand to do one.(Cut to size and router edges. Hope to get faster)
I am looking to dive into the CNC router market (stinger II).
Thanks
Scott