This is the Spalted Ambrosia Maple bowl that I have been working on. I turned it outboard on my 1642. It finished at just over 17 1/4" and is about6" tall. As you can tell the bowl is turned from end grain and that is the reason for the beating. I found the best results were from a round nose scraper. It was the only tool that I could get anything other than sawdust off of. It is sanded to 400 grit and has 2 coats of Walnut oil finish. It darkened a little more than I would have liked but I am proud of the bowl. I like the bigger bowls but NOT the end grain. The last picture is the home made tool rest that I used for this project. I hope you enjoy and thanks for looking. Russell