Don't know what's causing this, but I'd love some advice how to eliminate this problem. I'm getting lots of small bubbles in the finishes I'm spraying with my HVLP gun. I'm a total HVLP newbie, so I'm not sure where I'm screwing this up. I'm using a Fuji XPC gun, and a Fuji Gold 4 HVLP turbine. Using a #3 needle/aircap (1mm, .039").

The bubbles remain after the finish dries, and are permanent.

Here's a picture of how they look:

IMG_1372-for-web.jpg

Any clue as to what is causing this, and any suggestions for eliminating the problem?