I am not new to spraying lacquers.... I have a spray booth, airless spray equipment and also just got an air assisted airless to spray with. I have sprayed MANY gallons of ML Campbell Magnamax in my shop but......
It is cold here right now, low 30's(SE Ohio) and I am having a ROUGH time getting my finish to come out well on this current project. I have the heat cranked up in the shop to about 75deg and an extra heater running in the spray room to keep the temps up. The paint can WAS sitting on the concrete floor but I have it elevated now hoping to raise the temp of the paint as well.
I am getting pin holes in the finish and if I apply enough paint to fill the pin holes I'm getting sagg/curtaining in my finish(on vertical surfaces). I'm going nuts trying to get this good!! And getting sick of sanding the runs back out!!
Any ideas or advice?
Thanks,
Nick