Cut out flames

[Joe Kace]

Hey everybody..

I have this order for a led lit sign and the customer is looking for the top edge to be cut with a flame design. I have looked for something comparable that I could use as a starting point but no luck and I am no artist. Does someone have a file for something like this they would like to share. The edge length is 2 ft.

thanks in advance

Joe

[Mike Null]

Joe

If you're using CorelDraw there are probably some in your art files.

I just checked X3 and there are about 20 flame files there.

[Bruce Clumpner]

Here's something that might work....It tiles pretty well for longer edges

[Joe Kace]

Mike,
Where do I look in Corel? I didn't even know they had art files.

Joe

[Mike Null]

Joe

You should have received several discs depending on which version you have. Normally your clip art files are on number 2 or 3 as well as your font files. Photos are usually on the last disc.

In X3 the clip art is on 2.

[Joe Kace]

Hi Mike,

I just located them on disk 2. I thought about this when you mentioned but I never booted those other disks. I didn't see anything but it looks like Bruce has something that will work.

Thanks
Joe

[Joe Kace]

Hi Bruce,

I owe you one, those are perfect.

Thanks a lot

Joe

[Bruce Clumpner]

Don't forget to show everyone what you've done

Hi Mike,

I just located them on disk 2. I thought about this when you mentioned but I never booted those other disks. I didn't see anything but it looks like Bruce has something that will work.

Thanks
Joe

[Joe Kace]

I would, but I don't think it's suitable to show on this forum. I'm not exactly excited about the wording on this job but money is money and it's not going in my home.

Joe

[Mike Null]

Joe

Here's a look at some of the files on the cd.