Does anyone know is the Chinese controller software Easycut a version of Lasercut - relabeled?
Is it being used with any other controller other than the Leetro controllers (6515/6535 etc?)
Thank,
Vicki Rivrud
JR Laser Solutions
Does anyone know is the Chinese controller software Easycut a version of Lasercut - relabeled?
Is it being used with any other controller other than the Leetro controllers (6515/6535 etc?)
Thank,
Vicki Rivrud
JR Laser Solutions
Hi Vicki,
my Redsail runs from Easycut 5.3, this is simply Lasercut rebadged by Redsail........
John
Thanks for the reply . . . which controller comes with your Redsail?
Hi,as far as I am aware it is the 6515 controller.john