Hello everyone.
Im working on an unusual project which requires a teak deck.
The unusual part is its in a smaller scale.
It has to have 3/32 inch planks laid out to form a teak deck on a 20 foot scale warship.
After much experimenting with teak veneer, I have managed to make planks the correct width.
As a relative novice to this part of the model, I have the need of you folks knowledge when I lay it out on the ship.
Specifically as to what glue to use to glue the strips down. And what to seal the deck with after its down to make it waterproof.
It will probably be glued to 5mm plywood(luan) although I have considered using an abs plastic underlay.
If I use the luan it will also have to be waterproofed before I lay the planks. I have been using fiberglass resin to coat the wood on other parts of the ship.
I thought I would see if you have any suggestions.
There is such a wide selection of glues and construction adhesives that I am definately not experienced enough to make the right choice.
Any help help would be welcomed.
Nice to meet all of you.
Matt