Just got a sample of corien in & was working on my 3rd pen this evening. Finished 2 of them Sunday evening. Was getting ready to start sanding this one down & noticed a crack near the barrel area of the pen. Decided I didn't really want to toss out this blank. So took the skew & started cutting out the cracked area. So pulled it off the lathe & decided to change direction with the pen. Decided it needed a new nib area. Found a dark grey piece of corien that seemed like it would blend in. Did a quick glue up & then finished turning it.
coriensand1a.jpgbluecorien1a.jpgmarooncorien1a.jpg