I've attached photos of a laundry rack for hanging hangers I plan to build out of 4/4 maple.
I am fairly set on the design but only so long as I can figure out a way to accurately "dado?" one piece into the other. I plan to have lower support remain whole while removing half the material width out of the upper support.
Any suggestions as to how to go about accurately removing half the material from one curved piece and making them seamlessly fit together?
After they're glued up I'll complete the though tenon.
Thanks for the help.
laundry rack 01.jpglaundry rack 02.jpglaundry rack 03.jpg