I'm putting together the shop in my new house and I was planning to drop my router into the table saw extension as I had done before. However I remember what a pain it was to get everything set up and then have a need to make a quick cut on the table saw. I don't really have room for a dedicated router table, but I'm planning to build a set of cabinets and a large table top for the miter saw and thought what about dropping the router in there?
Has anyone else done this? Just wondering if I'm overlooking any obvious problems. I would be limited to about 4 foot long work pieces. I wouldn't be able to do a dado deeper than about 12 inches from the edge. I think I can live with those two limitations. Anyone else see any gotchas with this setup?
Kurt
Reply With Quote