Beautiful work!
Beautiful work!
Dennis
Beautiful work, Martin. And I can't see the filled gap in the dovetails. Funny that we can always see things in our work that are apparent to nobody else.
Fun project and very well done. I love the end grain contrasting color!!! I think those DTs are awesome and even up close it would be very hard pressed for anyone other then an expert DT master to see an issue.
Great Project!!
jon
Martin!! You must be practicing dovetails during those long cockpit hours over large bodies of water... Of course, that's probably hard with a plastic saw...
Seriously, Wonderful! I really like that tray.
--
The most expensive tool is the one you buy "cheaply" and often...
Martin, Well done!
TJH
Live Like You Mean It.
http://www.northhouse.org/
Very Nice Martin! Great job on the dovetails and the finish.
Brad
Martin---The trey is superb. The dovetails look great, the has nice figure, finish is well done. I'm sure you will get a lot of comments at those pot lucks.
The "curved sides" are likely the result of using a wide angle lens for close ups. If you step back a few and use a bit of zoom, things will straighten out.
Dan
Eternity is an awfully long time, especially toward the end.
-Woody Allen-
Critiques on works posted are always welcome
Martin,
That is a very tidy piece of work. Good job!
Alan Turner
Philadelphia Furniture Workshop
A nice piece of work Martin and I'm sure your wife will find a lot to use it for-- probably more than just as a silver caddy. I love figured woods. Aren't you glad you popped the grain with the oil?
Dave Anderson
Chester, NH
Martin,
Great idea to make the tray a logical size for todays kitchen technology!!!
Finish is beautiful and the DT's look Fantastic!!! Great, great job!!!
Matin, That's a wonderful piece. Your dovetails look beautiful. -Steve
Very, very nice, Martin. How about more info about the bottom, such as thickness, is it in a groove, how thick a groove, etc.
Pam
Hi Martin,
Very nice work! I really like the dovetails and the overall design.
JM
Pam,Originally Posted by Pam Niedermayer
The bottom is 3/8 inch thick, as it is resawed from a 4/4 board. This was the board I was trying to resaw in my MM16 post a while back. I resawed, then bookmatched glued it, then ran in through my drum sander to 3/8, and used a 3/8 dado buried in a tail for the joinery. After glue up, I had to use little 1/4 by 3/8 wooden plugs to fill the gap in the end of the tail, but they disappeared pretty well. Next time I need to get one of those special handplanes (witch's tooth?) and take the time to use a router instead of a tablesaw and do stopped dado's. (There is always room for improvement, and a new technique to incorporate.)
Thanks for asking, Pam. I'll try to find that book, so I can quote the title and page number in case someone wants plans.
Martin, Granbury, TX
Student of the Shaker style
Martin,
Looks great..thanks for sharing the design and construction methods with us. Course I now have one more "I gotta build one of those" things on my to-do list
Really looks great, and those dovetails look fine!!
Roger