Hello, first time posting here.
I have a couple questions about one of my machines, maybe someone could help me out with.
When I turn my Accuris engraver on, it starts the X Y homing. The Y does fine, but the X tracks all the way to the left of the table then just sets there and wants to keep going left. I have cleaned all the tracks, rails, disconnected and reconnected everything on the machine.
I called Sigh Warehouse (seller), there Tech Support said to open side panel where the control boards are, then disconnect and reconnect every wire. This didn't help at all.
The next step was to test he X axis motor cable that connects the X motor to the controller board. Here is what he said "If you can find connectivity between a wire on the PCB board and the controller board the cable isn't the issue. At this point you are looking at a controller board or the main board." Well with my luck I found connectivity.
Here is my problem, the machine is only 4 years old, but Sign Warehouse wants 714.60 MOTION CONTROLLER WITH PLATE (Controller Board) and
1,616.40 CONTROL MODULE (Main board). Plus $2000.00 plus parts to fix it. So $4500.00 into a 4 year old machine
Does anyone but Sigh Warehouse work on these machines?
Thanks for your time.