When I reset the laser or hit focus, it makes a funny noise in the top left corner. Does not when it is engraving, but when I cut, it cuts wierd when going up not across....any thoughts.
Tim
Epilog Helix 45 W
When I reset the laser or hit focus, it makes a funny noise in the top left corner. Does not when it is engraving, but when I cut, it cuts wierd when going up not across....any thoughts.
Tim
Epilog Helix 45 W
Tim Baude
Legends Awards & Custom Engraving
Epilog Helix 24, 45w, CorelDRAW X4
If you are getting a twang like a guitar string, then its probably a belt tension issue. Easy fix.
Epilog 35 W 12x24
Adobe Illustrator
Dell PC
More of a grind...... When I turned on the machine today, it didn't do it. Then the X Y became disabled. Came unplugged. When I plugged back in, the grinding was back. Again only when it moves so I can focus and when I hit reset.....
Tim Baude
Legends Awards & Custom Engraving
Epilog Helix 24, 45w, CorelDRAW X4
I don't have any experience with Epilogs, but could one of the bearings on for the y axis be not rolling smoothly? Or is the track that the bearing rides in dirty? Both of those problems cause a grinding noise and engraving problems on a Universal.
Universal M-300 (35 Watt CO2)
Universal X-660 (50 Watt CO2)
Hans (35 watt YAG)
Electrox Cobra (40 watt YAG)
Glass With Class, Cameron, Wisconsin
Now isn't doing it.....and cutting was spot on....
Tim Baude
Legends Awards & Custom Engraving
Epilog Helix 24, 45w, CorelDRAW X4
I'll be watching this one. I replaced a stepper motor on my ULS when it was making the noise, didn't help. I thought it was either a limit switch, or the motor. Hope someone has the answer.
I don't know the machine. But the focus is the Z motor, right?
Sounds like you have a bad limit switch for the home position.
Also make sure all your rulers are down. Inevitably at one point in time or another, the operator neglects to put one of the rulers down, ( usually the one on the extreme right side )
Life and death don't bother me. It's that little period of time in between that bothers me.
Epilog Mini-24 40w with Rotary, Flame Polisher, CorelDRAW Graphics Suite X6, EngraveSoft, Windows 10 64-bit.
I had a problem with my belt vibrating and the carriage would make a grinding noise (I have an Epilog as well). All it needed was tightning...not sure if this is your problem. Here's a link for the fix:
http://www.LiveHelpNow.net/lhn/agent...ini+x+belt.pdf
Epilog 35 Watt Mini 12" x 24"
New Hermes V3400
Kwikprint 55
CorelDraw 2017, Illustrator, Photoshop
Right about that Greg. I removed the right side ruler. It wasn't doing me any good and I forgot it was up one time too many.
Dave
Epilog 35 W 12x24
Adobe Illustrator
Dell PC