[OP]
Member
I started this last June but it was to big for the lathe I had at the time .I went an picked up a nova dvr 2 weekends ago .I had no problems turning it on the nova lathe . Real smooth and turned nice.I it 25 in tall an 15 in wide walnut maple cherry and yellow heart.
Last edited by Chip Nasworthy; 02-04-2013 at 2:40 PM.
Member
Mighty pretty and an impressive size too! Hope you continue to enjoy the new DVR also.
Member
How did you manage to mount that?
Veni Vidi Vendi Vente! I came, I saw, I bought a large coffee!
Member
Very nice Chip. The people that do segmenting have a lot of patience.
Member
I'm glad you finally got that one finished. You did a nice job on it too.
Member
That is a large vase. I am wondering about how you turned the inside. I would think that a steady rest and a large boring system would be required.
[OP]
Member
I started at the bottom and turn the inside as I added the rings and I also started at the top and added the ring down the vase, an turned the inside of the top .Than tried to get them to join as close as possible to meet both insides together when they med .I also used a steady rest.
Last edited by Chip Nasworthy; 02-09-2013 at 10:10 PM.
Posting Permissions
Reply With Quote