Hey guys
I made a lot of small pegs that are about 1/4" wide and 1/2" long. Trying to figure out how cut them quickly. Was thinking some kind of core drill would be nice, but I'm open to suggestions.
Hey guys
I made a lot of small pegs that are about 1/4" wide and 1/2" long. Trying to figure out how cut them quickly. Was thinking some kind of core drill would be nice, but I'm open to suggestions.
How about a plug cutter? Such as:
plug cutter
Or a tenon cutter:
tenon cutter
Or a 1/4" dowel cut to length.
"When the horse is dead, GET OFF."
They are made of various exotic hardwoods, so the plug cutter is going to be the trick. Thanks!