I am having a rather severe issue with my laser at the moment.
When I send large files to be engraved to the laser it starts off fine but after engraving for a little while the head will suddenly decide to head to the left side of the laser and then when it gets to the end of travel it tries to continue past that point) into the left side and then it jumps the belts and is no longer set for the same starting point.. I have to stop the job and press datum to get the head to reset its X/Y positional data... This is not an issue with me trying to push the laser to engrave to fast as it happens at the same point with a specific file whether Im engraving at 100mm or 600mm. It has done this on several different files that were large. When I reduce the size or complexity of the engraving this does now happen. I have been working with G.Weike on this but they haven't come back with anything yet and I have work to do!!!!
Like I mentioned it seems to be file size dependent... It seems that the laser is somehow resetting its X-Y data and thinks the head is in a different position than it actually is???
Any and all help would be greatly appreciated.