This may not be what you guys think of when you hear "Metalworking" but it's about as close as I will ever come.
I'm trying to cut out initials in this piece of aluminum stock. I'm pretty limited on tools. By that I mean to say, I have a Dremel
I should also add that the finished initials will measure at or below 1" x 1", preferably a little smaller, maybe 3/4" x 3/4"
Off hand does anyone know the bit(s) I would need to cut through this material?
Aside from the dremel route is there an economical way to cut the initials through?
Hope I don't sound completely stoopid!
Oh, the stock I'm using...