Not a big deal but I noticed that a couple posts were deleted (one of mine) from the Engravers Forum. Just curious if some rule was broken. Sure didn't think so. There is another post with the same content there today.
Jeff Belany
Not a big deal but I noticed that a couple posts were deleted (one of mine) from the Engravers Forum. Just curious if some rule was broken. Sure didn't think so. There is another post with the same content there today.
Jeff Belany
SawmillCreek.org
[SIGPIC][/SIGPIC]
45W Epilog Helix
Corel X4, Photoshop CS3
Sherline 4400 lathe
JET 1221 Lathe
JET 1014 Lathe
Craftman 36" VS lathe
Jeff,
I had to do a bit of house cleaning in a particular thread as things were going a bit off topic which caused some sub-posts to wander even farther from the point of interest. Nothing earth shattering!
.
Not going to argue. The post only had a handful of replies and didn't sees off topic at all.
Jeff
SawmillCreek.org
[SIGPIC][/SIGPIC]
45W Epilog Helix
Corel X4, Photoshop CS3
Sherline 4400 lathe
JET 1221 Lathe
JET 1014 Lathe
Craftman 36" VS lathe