This is only partly a woodworking question but I know a lot of you guys have conversion guns. I am totally ignorant in spraying and have only done spraying out of a can. That is pretty much my knowledge of spraying as well.
What brings me to wanting to start spraying is a house remodel. I would like to use this in my woodworking later, but my main purpose is spraying doors/trim. I will be repairing and painting every door in this house by the time I am done and painting all new trim for the house. I would very much like to be able to spray all of this and would like to use satin acrylic enamel.
I read Jim Beckers review on the Wagner HVLP Conversion Gun(BTW, nice review Jim) and that seems like an affordable option if it can handle what I need. Currently I only have a 2HP portercable pancake compressor, which according to what I have read would be sufficient for this gun but would like some opinions on that as well.
Will this gun do what I need? Is there a better opinion without spending a lot?
Any thoughts, advice, comments are greatly appreciated.
Thanks
Matt