Purchased at auction and not sure I can or want to use it. I have no experience with this product. Is this jig a practical general use router fence or is it really only for joint making? It's a 24 inch model and too big to fit my router table top. My RT is my TS extension wing and the router plate is placed so that routed stock is fed parallel to the TS fence. I gather the actual aluminum jig base is mounted to plywood which can then be clamped or otherwise attached. Could it be attached to the TS top or would that make switching between tools too time consuming? Would it need to be indexed so it was attached in the exact position each time? I know I could just try it but the box is unopened and I prefer to keep it that way in case I decide to sell it. Also is this a practical fence for use on a table saw? Could the jig base just be rotated between tool tops so the fence is usable for both? Hope that all makes sense. Thanks, Mike