Need rewiring help for Delta Invicta RS-15 Shaper

[J.R. Rutter]

I think you're good. That's how I've done it in the past.

[Chris Rosenberger]

The only changes that need to be made in the starter is move the wire on the transformer to the 230 volt pole (done) & change the 3 overload heaters to something close to 20 amp. The overload block is in the upper left corner of your picture. The overload heaters are held in by the 6 screws in the middle of the block.

[Keith Weber]

It runs! Started up quick and runs smooth and quiet. Thanks a million for everyone's help! Now I just need to drill the top for the Powermatic PF-31 power feeder I got on Craigslist a while back. I'm thinking of mounting it towards the back left corner. Is there a standard convention for mounting them?

Chris,

Thanks for the heads up on changing the starter motor heaters. I'll admit I didn't really know what a heater was, but I just found a couple of excellent videos explaining motor starters and starter motor heaters on YouTube. They're done by the username LewellynTechnology in case anybody else is interested.

Keith