Hi All
Although I have read extensively on this forum, this is my first post and I am hoping that the community can help me with a little bit of information.
After reading through the very useful post here, I have decided to buy a Laser Cutter from Shenhui Laser. The Specs and extra's that I have decided on are as follows.
SH-1390 RECI 80W LASER MACHINE with the CW5000 chiller (I belive this is best choice if you want to cut and engrave)
1 x cylinder rotary
1 x irregular rotary
1 x additional 80W Reci tube
3 x imported lens (40mm)
3 x mirrors
1 x 80W power supply
1 x RD-320motherboard
1 x lcd panel
1 x stepper motor for XY
1 x stepper motor for Z
1 x stepper driver
1 x belt set
1 x honeycomb table
1 x alu knife table
Are their any more spares that should consider getting, or any special instructions I should give to the seller? I have seen mention of getting additional head assemblies. Also is it necessary to purchase additional lenses with different focal lengths. I would rather spend a little extra and cover my bases now, then have to reorder small parts at a later stage. Any advice would be greatly appreciated.
Finally, could some one please supply me with the banking details that they used when they transfer money to Shenhui, as I have recieved banking details from a referance they gave me, but I belive their bank account number may have changed since then, and I just want to confirm the details I have been given.
Kind Regards
Brent