My New Hermes rep asked me if I'm supposed to use de-ionized or distilled water in my new laser?
Should I?
Instructions don't say- in one place it says simply "use pure water"...
[OP]
Contributor
My New Hermes rep asked me if I'm supposed to use de-ionized or distilled water in my new laser?
Should I?
Instructions don't say- in one place it says simply "use pure water"...
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now- fiber lasers
ONE - vinyl cutter
CASmate, Corel, Gravostyle
Contributor
Distilled would be the purer version..
Mark
In the Great Northwest!
Trotec Speedy C25, Newing-Hall 350 (AMC I & HPGL), NH-CG-30 (Carbide Cutter Sharpener)
Sawgrass 400 Gel Ink Printer, CS5, 5/9/x6 CorelDraw
Member
There are some circumstances when de-ionised is bad Kev (dissimilar metals, joints etc) , as Mark said Distilled is usually good
cheers
Dave
You did what !
[OP]
Contributor
That's what I wanted to know--!
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now
ONE - vinyl cutter
CASmate, Corel, Gravostyle
Posting Permissions
Reply With Quote