<--- new to the Monster tools hollowing system. I was hollowing last night and noticed that I could not get the tool rest low enough on my Jet 1648EVS to get the cutting edge of the hollower at the centerline of the piece. It meant I had to make the hole in the end larger to allow the tools to enter and hollow (not that big of a deal), but I also realized as I got to the bottom of the piece that I could not flatten out bottom. There was a rise at the center because I couldn't get the tool lower. Is this normal with the tool rest of this lathe (it's the stock rest). Do I need to buy a shorter tool rest for the monster? Or is there a different solution? Thanks.
Jon