I have 3 sections of laminated SYP for my workbench top. Each of the sections is 4 1/4 x 8 1/4 x 59". If I make light passes, would this be too much for my Ridgid planer (R4331)?
Thanks,
chip
I have 3 sections of laminated SYP for my workbench top. Each of the sections is 4 1/4 x 8 1/4 x 59". If I make light passes, would this be too much for my Ridgid planer (R4331)?
Thanks,
chip
You can make light passes through that planer on southern yellow pine. It would present no problems. It's actually a very decent planer. Just ensure you have good infeed/outfeed for the task.
Thanks, Rich. That was my thinking, but wanted some verification.