This week Norm did a custom "builtin look" Library system. Great ideas in this show. The reason for my post is, I want a little circular saw like norm used in the show today. It was a smaller light weight saw, just what I want for breaking down sheet goods and using on my edge guide as Norm was using as well. Even if I buy an EZ guide later, this looks like a good choice for me. Anyone know what this saw is? I suspect that it was a PC but it sure didn't look like the PC's I have seen.
ALso how about that pocket hole jig that Norm was using. It appeared to be a Delta?? product. It's application was a little bit different though it seemed. It drilled the pockets so that the entire interior of the pocket was open and the screws were run all the way to the bottom face of the hole. Maybe it was just the way he had it set up, but for 1 1/2 face framed, it would have blowed right out.
Anyway, anyone know the make on the CS he was using?
Thanks, Ok back to plastering and stucco.
Corey