Hello again:
I just saw this shaper on CL:
http://buffalo.craigslist.org/tls/4361625066.html
I have only used my router in a router table I have built. The router is the smaller PC unit (1+ hp), not the 3+hp unit, I don't remember the model (660 maybe?). At times, I am pushing the unit too hard for its HP. Would this shaper be a good shop addition? Are shaper cutters pretty standard size (bore, etc)? How much do you guys use your shapers? Would it be better to have a stronger router and use it in the table when necessary?
Thanks
Steve