I know there was a thread on this but I can't find it so I am asking.
I am making 6 legs, they will be 3x3x18 and I am using the lock miter bit for the joints.
1. Is there a better way to make them and not use the lock miter?
2. When using the lock miter do you do 2 parts with the same edge and then the other 2 with the matting edge to make the assemble easier?
3. What clamps do you use when gluing then up?
4. When gluing do you worry about getting glue down in the small groove of the joint?
5. Do you make them like a 1/2" longer and then cut them down to size?
Thanks......