Just installed my bench vice and I was wondering what you all use for the clamping surface on your vice?
Just installed my bench vice and I was wondering what you all use for the clamping surface on your vice?
I use pine scraps. I was taught it should be softer wood than anything you would put in it.
I have had a couple pieces of plywood as the faces on my vise for about 20 years. Works great.
-Alden
I use HM. I don't clamp with enough pressure to transfer any witness lines from the vise to the workpiece.
When I started woodworking, I didn't know squat. I have progressed in 30 years - now I do know squat.
BB ply works for me.
I use leather.
Thoughts entering one's mind need not exit one's mouth!
As I age my memory fades .... and that's a load off my mind!
"We Live In The Land Of The Free, Only Because Of The Brave"
“The problems we face today are there because the people who work for a living are outnumbered by those who vote for a living."
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." Winston Churchill
Hard maple
I used some scraps of Jatoba from a previous project. Jatoba is even harder & denser than Hard Maple. I figure it should way outlast me. Then I did put some leather on the movable face for enhanced grip.
2012-09-28_11-15-42_608.jpg 2012-09-28_11-15-32_369.jpg Shop - 12 My Bench B.jpg
"I've cut the dang thing three times and it's STILL too darn short"
Name withheld to protect the guilty
Stew Hagerty
Heck, I just used Masonite. Like Kent, I don't squeeze that hard. In my case, I am just trying to avoid scratches from the metal corners.
Rick P
I have covered the metal vice jaws with ash, it matches my workbench
Do yourself a favor and get the self-adhesive rubber vice face material from Woodworker's Supply. No relationship to them - just my favorite vice face material ever.
I use MDF, with some rare earth magnets epoxied into it.
Doc
As Cort would say: Fools are the only folk on the earth who can absolutely count on getting what they deserve.
Russian/Finland birch plywood when I've got it, other wise regular birch. 1/4" thick put on with contact cement. Replace them every few years easily with a little lacquer thinner and a putty knife. The 1/4" faces don't occlude the opening capacity as much as 3/4 faces do. Birch plywood is spongy enough not to risk marring most work when you've got to romp down on the handle.
Red oak scrap on both and added leather on the moveable jaw.
Shawn
"no trees were harmed in the creation of this message, however some electrons were temporarily inconvenienced."
"I resent having to use my brain to do your thinking"