I have a Ridgid TS3650 and love it! My only problem is when we moved I have a smaller workspace so I need to save EVERY inch. I've considered moving the motor to tuck it low and UNDER the table (like it would be on a cabinet saw) and using a longer belt. Especially with any tilt I know that would be a problem if I were to just remount it, but has anyone seen this done? I couldn't find any resources that recommended how or if it was possible. I'm pretty handy and willing to do a bit of metalworking to make any brackets etc. that might be needed to make this a possibility...if it could work.