Mike I thought you listed you vendor for the infloor heating system parts and design . Can you re post ? thanks Dan Nelson
Mike I thought you listed you vendor for the infloor heating system parts and design . Can you re post ? thanks Dan Nelson
If you watch his videos, he states that he got the in floor tubing/manifolds from Blueridge Co. As did I. They are a very good company to work with, and quite a bit cheaper than Menards.
Thanks dan
I built the panel myself. Studied the panel at Menards and the hydroshark panels on their site. I ended up going with larger pumps on the primary and secondary loops and still saved more than half the money.
Glad its my shop I am responsible for - I only have to make me happy.
Thanks Mike, would you mind shooting me a email ? I have some off line questions I would like to ask you if you could spare the time. Thanks Dan . nelsonwoodcrafters@yahoo.com
I would put the idler motor outside. I did that with my 15hp when I had to run a rpc, so much quieter.
My purpose made RPC shaftless 20hp Baldor ideler is darn near silent. Not sure what noise you guys had with yours but it sure does not warrant a separate anything.
Glad its my shop I am responsible for - I only have to make me happy.
Doesn't sound very silent in those videos. Far from it.
The ideler is about the same noise as a drill press. Plus with the shop's size, that ideler running will be all but silent when you are by any major tools.
Last edited by Mike Heidrick; 09-12-2017 at 1:42 PM.
Glad its my shop I am responsible for - I only have to make me happy.
Mine lasted about a week inside. So much more peaceful when I stuck it outside. Now that I have 480v pole power the only thing annoying are the two big transformers.
The closed cell foam insulation team I hired arrives tomorrow to spray the ceiling and gable ends of the shed in 3" of closed cell 2lb foam. I have the East 40X32 bare and after that is done we will move a few tools and the pallets of ply over to the east and they will spray the West 32X40. Wish me luck the next couple of days
Glad its my shop I am responsible for - I only have to make me happy.
They got 3/5 of the spray foam done today.
Glad its my shop I am responsible for - I only have to make me happy.