Hi All, I am wanting to flatten the soles on a couple of my larger planes. I have a large granite stone, specifically made with an ultra flat surface I can use for my smaller planes, but it is too small for my bigger planes.
What is a good set up to do this with? I know David mentioned in another post that it is not difficult if you have the right set up.
Do you use special metal cutting sandpaper, etc., and if so what brand, product number, grit size, etc., do you use? What do you use to glue the stuff down, etc.
Also, it seems like a read a while back, while just a reader of the site, that one of they guys here is a machinist that will mill the sides and bottom flat, am I correct in this?
Any help will be appreciated.
Thanks and regards,
Stew